Question 1

What micron rating do I need for well water sediment?

Accepted Answer

The right micron rating depends on your sediment type. Visible sand or grit typically requires a 50-100 micron spin-down filter. Cloudy or hazy water from fine silt needs 1-5 microns. Rusty or orange water from iron particles is best handled with a 5-20 micron pleated filter.

Question 2

What is the difference between a spin-down and cartridge sediment filter?

Accepted Answer

A spin-down filter uses centrifugal force to separate large particles and can be flushed without replacing the cartridge, making it ideal for heavy sand loads. A cartridge filter (pleated or spun poly) traps finer particles but requires periodic cartridge replacement.

Question 3

Should I install a sediment filter at the point of entry or point of use?

Accepted Answer

For well water with significant sediment, a whole-house point-of-entry filter protects all appliances and plumbing. A point-of-use under-sink filter is suitable if you only need clean drinking water and your sediment levels are low.

Question 4

How often should I replace a sediment filter cartridge?

Accepted Answer

Replacement frequency depends on sediment load. In most homes, cartridges should be replaced every 3-6 months. If you notice reduced water pressure, replace the cartridge immediately regardless of schedule.

Question 5

Is this sediment filter selector tool free?

Accepted Answer

Yes, the Sediment Filter Selector is completely free to use. Just answer three quick questions about your water appearance, flow rate, and installation preference to get an instant recommendation.